Words start with letter ‘F’

Check any word shown or choose below the wanted one and see the definition

Fiber – For the purpose of microscopic particle counting a fiber is a particle whose length is greater than 100 micrometers but at least ten times its width.

Fill port – A port which provides a passage for filling purposes.

Filler ring – A ring which fills the recess of a “V” or “U” type seal.

Filter accessories – Auxiliary devices incorporated into a filter to enhance its usefulness.

Filter efficiency – The ability, expressed as a percent, of a filter to remove specified artificial contaminant at a given contaminant concentration under specified test conditions.

Filtered by pass hydraulic filter –  A hydraulic filter in which by-pass flow is filtered through a reserve filter element.

Fire resistant fluid – A fluid difficult to ignite which shows little tendency to propagate flame.

Fitting – A connector or closure for fluid power lines and passages.

Fixed displacement hydraulic motor – A hydraulic motor in which the displacement per unit of output motion cannot be varied.

Fixed displacement hydraulic pump – A hydraulic pump in which the displacement per cycle cannot be varied.

Flange – A mounting device consisting of a plate or collar extending past the basic cylinder profile to provide clearance area for mounting bolts. A flange is usually at right angle or normal to the piston rod center line.

Flash point – The temperature to which a liquid must be heated under specified conditions of the test method to give off sufficient vapour to form a mixture with air that can be ignited momentarily by a specified flame.

Float switch  – an instrument  which is responsive to liquid level.

Flow control valve – are used to keep a set flow constant regardless of pressure variations. Furthermore the basic function of the valve is to reduce the volume of oil supplied in different places in a hydraulic circuit. 

Flow dividing valve  – A valve which divides the flow from a single source into two or more branches.

Flow meter – A device which indicates either flow rate, total flow, or a combination of both.

Flow metering – See: Flow control valve

Flow rate – The volume, mass, or weight of a fluid passing through any conductor per unit of time.

Flow switch – An instrument  operated by fluid flow.

Fluid – A liquid, gas, or combination thereof.

Fluid level gauge – A gague which indicates the fluid level at all times.

Fluid power – Energy transmitted and controlled through use of a pressurized fluid.

Four position valve – A directional control valve having four positions to give four selections of flow conditions.

Fretting – A type of wear resulting from minute reciprocal sliding motion which products fine particulate contamination without chemical change.

The post is filled under Hydraulic Glossary

Have a comment about this topic! Share it here

Hydraulicstroubleshooter
Logo