Words start with letter ‘S’

Check word shown with letter *S or choose below the wanted one and see the definition.

Safety circuit – A circuit which prevents accidental operation, protects against overloads, and assures safe operation.

Safety relief valve – A relief valve whose primary function is to provide pressure limitations after malfunction.

Schematic – In order to check the function of a hydraulic machine it needs a hydraulic schematic. A diagram consists of a number of symbols. To ensure that everyone can read the symbols, international standard symbols are use.

Schematic symbol – The symbols represent a specific function. Furthermore the important thing is the function it perform not the actual construction or the basic operation of the component.

Scoring – Scratches in the direction of motion of mechanical parts caused by abrasive contaminants.

Screw pump – A hydraulic pump having one or more screws rotating in a housing.

Sequence valve – A valve whose primary function is to direct flow in a per-determined sequence.

Servo circuit – A circuit which is controlled by automatic feed back; e.g. the output of the system is sensed or measured and is compared with the input signal. The difference (error) between the actual output and the input controls the circuit. The controls attempt to minimize the error. The system output  may adjust  velocity, force, pressure level, flow rate, or temperature.

 Servo control – A control actuated by a feed back system which compares the output with the reference signal and makes corrections to reduce the difference.

Shut off valve – A valve which operates fully open or fully closed.

Shuttle valve –

Slit – Fine particulate matter, generally less than five micrometers in size.

Single acting cylinder – It have a robust body or cylinder barrel, an enclosure at each end and a movable piston attached to a piston rod. At one end there is an inlet port by which oil enters, and at the other end there is a vent port to allow air to escape when the piston moves.

Sludge – Particulate contaminant or a mixture of a particulate and liquid contaminant separated from the fluid in an unconsolidated state.

Solenoid – a type of energy transfer – electrical type.

Spool type directional valve – The most common type, the spool moves within the valve housing to connect inlet and outlet ports. Directional spool valves may be either direct or pilot operated.

Spring mechanical accumulator – A mechanical accumulator in which springs apply force to the stored fluid.

Standard – A document, or an object for physical comparison, for defining product characteristics, products or processes, prepared by a consensus of a properly constituted group of those substantially affected and having the qualifications to prepare the standard for voluntary use.

Standard air – Air at a temperature of 68°F, a pressure of 14.70 pounds per square inch absolute, and a relative humidity of 36% (0.0750 pounds per cubic foot). In gas industries, the temperature of “standard air” is usually given as 60°F.

Stroke – The standard unit of kinematic viscosity in the c.g.s (centimeter (centimeter) -gram-second) system. It is expressed in square centimeters per second; 1 centistoke equal .01 stoke.

Stuffing box – A cavity and closure for sealing device.

Suction line – A supply line at sub-atmospheric pressure or vacuum to a pump, compressor, or other component.

Suction filter – maintains the oil clean by removing large solid particles from the fluid. The suction filter is make of wire mesh screens, which removes significant and large solid particles from a fluid.

Surge – A transient rise of pressure or flow.

Swivel joint – A joint which permits variable operational positioning of lines.

System pressure – The pressure which overcomes the total resistances in a system. It includes all losses as well as useful work.

The post is filled under Hydraulic Glossary

Have a comment about this topic! Share it here

Hydraulicstroubleshooter
Logo