Words start with letter ‘B’
Check any word shown with letter *B or choose below the wanted one and see the definition
Back pressure – is the pressure maintained on the outlet (return) side of a valve or actuator that resists fluid flow.
Back-up ring – A ring which bridges a clearance to minimize seal extrusion.
Baffle plate – is separating the pump inlet line from the return line; prevents the same fluid from circulating continuously within the tank. In this way, it is ensure that all the fluid is uniformly use by the system.
Ball seating action – A seating action valve design which uses a solid ball to obstruct the flow path.
Bar – A unit of pressure measure in MPA, pounds per square inch. Older unit of measurement such as Kgp/cm² is still in use. 105 N/m² (Newtons per square meter), approximately equal to 14.5 psig.
Base valve mounting – A valve is mount to a plate that has top and side ports.
Bi-directional filter – A filter element for flow in both directions.
Bladder accumulator – an elastic bag or bladder that separates liquid/fluid and gas in the accumulator.
Bleed off – A filter located in a line between a flow control device and tank.
Bleed port – A port which provides a passage for the purging of gas from a system or component.
Blind end – an end connection plug. E.g. a cylinder end closure.
Boil point – At boiling point, the pressure of the vapors at the liquid surface is equal to the external atmospheric pressure. Thus if the external atmospheric pressure increases, the liquid has to boil at a higher temperature to create a vapor pressure equal to the external pressure. At higher altitudes, the atmospheric pressure is low, hence water boils at a temperature lower than 100 °C (212 °F). This makes cooking difficult. An important point to be noted is that adding impurities to a liquid can increase its boiling point.
Bourden tube gauge – A pressure gauge in which the sensing element is a curved tube that tends to straighten out when subjected to fluid pressure and read out a pressure of a part of hydraulic system.
Burst– An outward structural failure of the hydraulic connection(pipe or house) caused by excessive pressure.
Bushing fitting – A short externally threaded connector with a smaller size internal thread.
By-pass indicator – An indicator that signals alternate flow. Usually find to filters for helping decide when required to clean it.
Check words shown with letter *B or choose the wanted one and see the definition
Have a word start with letter B want to know! Share here!
The post is filled under Hydraulic Glossary